I decide to use a christmas tree shaped cutter to create my test tiles. The first thing i did, after wedging my clay, was rolled my clay out into a slab. After this i used a wet rubber rib to smooth out the slab of any texture. I only did this to one side, because i knew i would only glaze one side. After i cut out as many trees as i could, i rewedged my clay, and used that to make more trees. After i had all my trees cut out, i used a pin tool to put the holes in them, i plan on stringing these together to create a hanging decoration. If i could change one thing about this project, it would be where i put the hole. I wish i put the whole through the side of the trees. I thing this would of looked better when i hung it, it would of made the trees lay flush with the wall, instead of at an angle.